REV 12.18.24 Pg.11 MAX
WHEEL INSTALL STEP 4
WITH THE QUICK RELEASE HANDLE ALL
THE WAY OPEN TIGHTEN THE AXLE NUT
ALL THE WAY UNTIL THERE IS SLIGHT
RESISTANCE, THEN BACK IT OFF 1.5
TURNS.
CLOSE THE QUICK RELEASE HANDLE SO
THAT IT IS PAST PERPENDICULAR AND
TIGHT.
IF THE HANDLE IS NOT TIGHT WHEN
CLOSED THEN TIGHTEN THE AXLE NUT
SO THAT THE HANDLE LEAVES A MARK
ON YOUR PALM WHEN CLOSED.
FOR YOUR SAFETY
CLOSE THE QUICK RELEASE HANDLE SO
THAT IT POINTS TO THE REAR OF THE
TRIKE
To Next Page
Loading...
