CBE PC-540HY - Stern Panel and Alarm Clock; Stern Panel Functions; Alarm Clock Setup and Operation

1
2
3
STERNPANEL
43
1)
2)
3)
FUNCTIONS
SET-UPANDFUNCTIONINGOFTHEALARM-CLOCK
Doglight switch, it depends on the main switch
Pushbutton for the setting of the alarm-clock; it is used to shift between hours and minutes setting.
Pushbutton for the activation and deactivation of the alarm clock and for the setting of the alarm-clock
time.
Thecurrenttime,externaltemperatureandburglardeviceandgasdetectorsalarmsaredisplayed:
- GAS ALARM
. Whenoneofthealarmsturnson,therelevantmessageisdisplayeduntilthereasonofalarmis
eliminated.
It'sononlywhenthecontolpanelisoninstand-bymode.
Thewatchiscontrolledtothecontrolpanel.
Tostartthesettingofthealarm-clockpushthebuttonref.2forabout2secs;hours’ digitsareblinking
onthedisplay.
Thebuttonref.3allowstosetthedigits.
Pushingagainthebuttonref.2,youcanshifttotheminutessetting;minutes’ digitsareblinkingon
thedisplay.
A thirdpressureonthebuttonref.2savestheset-up.
Aftertheset-upitisnecessarytoactivatethealarmpushingthebuttonref.3forabout2secs.
Thealarmremainsactiveuntildeactivatedbypushingthebuttonref.3.
Thesymbol onthedisplayshowsthatthealarmisactive.
Astheselectedtimeisreachedandthealarmisactive,thealarmclockstartsbeepingfor1minuteor
untilabutton(ref.2or3)ispushed.
-LEFT lockerforced ALMLKRL/H (OPTIONAL)
-RIGHT and/orrearlockerforced ALMLKRR/H-BK (OPTIONAL)
-Van'sdoorforced ALMDOOROPEN (OPTIONAL)
-Volumetricsensorsalarmwhentheburglardeviceisactivated"ALMVOLUMETRIC"
(OPTIONAL)
%
“ “
“ “
“ “
“ “
ENGLISH