Need help?Do you have a question about the CD Concept CD400 and is the answer not in the manual?
General| Form Factor | ATX |
|---|---|
| Memory Slots | 4 |
| Maximum Memory Supported | 128GB |
| SATA Ports | 6 |
| USB 3.2 Gen 2 Ports (Rear) | 2 |
| USB 3.2 Gen 1 Ports (Rear) | 4 |
| PCIe 4.0 x16 Slots | 1 |
| Ethernet | 2.5Gbps |
Defines a tachograph as a device for recording vehicle speed and distance.
Details the physical and electrical specifications of the CD400 programmer.
Explains the programmer's keypad layout and connector functions.
Describes how the programmer receives power and identifies the connected tachograph.
Illustrates the hierarchical menu structure for different tachograph models.
Details the process of measuring the 'W' factor for tachographs.
Describes the process of measuring the 'K' factor, available for specific models.
Explains how to perform manual and automatic speed tests.
Details the procedure for testing the vehicle's odometer.
Explains how to read Diagnostic Trouble Codes (DTC) from the tachograph.
Describes the process of erasing Diagnostic Trouble Codes (DTC).
Explains the sensor pairing process for digital tachographs.
Describes how to check the accuracy of the tachograph's internal clock.
Details the process of sending workshop card PIN codes to the tachograph.
Explains how to manually select the tachograph type if automatic detection fails.
Shows the software version and serial number of the programmer.
Describes how to change the display language of the programmer.
To Next Page