CD Concept CD400 - Digital VDO

Tachograph programmer CD400 - User manual – V2.00 r07 (9/01/2014) index
3.2.6. Digital VDO
DIGITAL VDO
1.Measure W
1.Manual
2.Photo sensor
2.Parameters
1.Calibration
1.W factor
2.K factor
3.L (Tyre Circ.)
4.Tyre Size
5.Max.Auth.Speed
6.Odometer
7.Time & Date
8.Next Cal. Date
9.Veh.Reg.Nation
10.Veh.Reg.Number
11.Veh.Id.Number
2.Other param.
1.ResetHeartbeat
2.TCO1 priority
3.O/P shaft
4.CAN rep.rate
3.Manufacturer
1.Part number
2.Drv1 ign.ON
3.Drv2 ign.ON
4.Drv1 ign.OFF
5.Drv2 ign.OFF
6.D1D2 Record
7.RPM Record
8.Speed Record
9.Install. date
10.ResetHeartbeat
11.CAN error
12.CAN2 TC01 mess
13.CAN2 WakeUp D3
14.CAN2RemoteDown
15.RD interface
16.Speed Warning
17.Illum.mode
18.IMS Activation
19.IMS source
20.IMS factor
21.VDO Counter
4.Information
1.Supplier Id
2.Manufact. Date
3.Serial number
4.Hardware number
5.Hardware vers.
6.Software number
7.Software vers.
8.License number
3.Speed test
1.Manual
2.Automatic
4.Odometer test
5.Read DTCS
6.Erase DTCS
7.Sensor pairing
8.Clock test
9.PIN code
10.Select Tacho.
11.Product info.
12.Language.
Page 10 sur 23