16 | Instruction Manual
Timed operation
Timed operation involves setting the duration after which the appliance
automatically turns o. You can set the duration from 1 minute to 23 hours
59 minutes. When the appliance is on or when you have turned the function
selector to a desired function press the (touch sensor) to set the
Duration. The indicator flashes and
dur
(duration) is displayed briefly for
1s and then
0.00
(or current countdown if the function is already active). Turn
the +/– to adjust the Duration and then press the button (touch sensor) to
confirm the setting or simply wait 5 seconds. The current time is displayed 5
seconds after you press the button (touch sensor).
The indicator is on during timed operation. The heating and temperature
functions can be freely modified during the time delayed operation.
To cancel timed operation set Duration to
0.00
and press the button (touch
sensor) or wait 5 s — the appliance will operate normally. Once duration has
elapsed, you will hear an [end] beep. All heating elements are disconnected.
You can silence the alarm as follows:
a) Do one of the following:
• press any button (touch sensor) except
• turn the function selector knob
• turn the +/– knob
• open the door
• This will clear all function and temperature settings. Even though the
Function Selector knob is set to a heating function, the appliance will
enter standby.
b) Turn the Function Selector knob to 0 - the appliance will enter standby.
c) Press the button (touch sensor) to set the new Duration and continue
cooking with currently set temperature and settings.
Note: in this case (when attempting to extend the Duration when the
beeping starts after the Duration has elapsed), setting the time to
0.00
turns
o the oven rather than allowing it to operate indefinitely.
To Next Page
Loading...
Need help?
General
