Instruction Manual | 17
Delayed timed operation
You can set the appliance, so that its timed operation is delayed and cooking
ends at a specific time.
You must first set the Duration (same as in timed operation). Press the
button (touch sensor) to confirm Duration and
end
message will be
displayed briefly for 1s and then End Time will be display calculated as
Current Time + Duration + 1 minute. Turn the +/– knob to adjust the End Time.
Press the button (touch sensor) to confirm End Time or wait 5 s to cancel.
Once End Time is confirmed the and indicators light up steadily and
the Current Time is shown again.
The and indicators are on during the countdown to Start Time. The
symbol indicates when heating elements are on. Press to view and
modify the set duration.
Pressing the button once to set Duration, press again to set End Time and
press again to display the current time. Set Duration to
0.00
to cancel both
Duration and End Time and allow the appliance to operate indefinitely.
You can adjust End Time from (Current Time + Duration + 1 minute) to
(Current Time + Duration + 10 hours). You can modify Duration (when End
Time is set) from 0:00 to (Duration – Current Time – 1 minute).
When you have finished cooking, set the function selector knob to 0.
Pyrolytic cleaning
The
P2.00
is flashing on the display and the indicator is on. Turn the +/–
knob to adjust the Duration to 2.00 - 2.30 - 3.00 hours.
Press or wait 20 s to start pyrolytic cleaning.
The Pyrolytic cleaning programme comes with special requirements. First,
the door status is checked. When the oven door is open, the indicator
flashes and the appliance waits 10 minutes until the oven door is closed and
if it is not, the pyrolytic programme is cancelled. When the door is closed the
indicator is on and the door is locked.
To Next Page
Loading...
Need help?
General
