10 | Instruction Manual
Standby mode
Switch the appliance to standby mode to reset all time, temperature and
timer settings. Heaters are disconnected. The display shows the current time
and has reduced brightness. Press the button (touch sensor) to adjust
the time, tone and brightness, and press the button (touch sensor) to
adjust the minute minder time setting.
If the temperature in the oven cavity exceeds 80°C, the current oven cavity
temperature is displayed (to indicate the residual heat) and the cooling fan
operates. When the temperature drops below 75°C, the cooling fan is turned
o and the current time is displayed instead of oven cavity temperature.
The appliance enters standby:
• Turn the function selector knob to position 0 at any time, you will hear a
beep
• After a power outage when set the current time
• After a timed programme completes (timed delayed operation, timed
operation, minute minder
• After activation of the Auto Shut-o Safety Device
• When you turn the knob to position 0 during a pyrolytic cleaning cycle,
the appliance activates cooling fan to unlock the door, and enters
standby only after the appliance has cooled down and the door is
unlocked
Activate the appliance from the standby mode:
Turn the knob from 0 to any available function to activate the appliance from
standby.
Note: if the appliance entered the standby mode automatically, you need
to first turn the knob to 0 and only then to another function. When the
appliance is in standby mode and the function knob is in a position other
than 0 - the indicator flashes.
To Next Page
Loading...
Need help?
General
