Cedima CF-2116 D - Connecting the Cooling Water to the CF-2116 D

ENGLISH
31
Installation and control elements
• CEDIMA
®
• Technical Documentation • All rights reserved as per ISO 16016 • Subject to modications due to progressive development •
CF-2116 D, rear pointer (mounted right) Fig. 4.33
rear pointer counter nut clamping screw
8. Re-tighten the counter nut and the clamping screw of
the rear pointer.
Front and rear pointer together with the saw blade
shall be congruent with the cutting line.
9. Fix the cord for raising the front pointer loosely to a
suitable place at the joint cutter, e. g. crane eye at the
control panel (section 7).
Make sure that the cord for raising the front
pointer does not form any danger and won’t be
endangered itself neither.
CF-2116 D standard, aligned pointers Fig. 4.34
CF-2116 D, aligned pointers Fig. 4.35
front pointer
push handles
(operator’s position)
rear pointer
cord,
guiding rod
diamond
saw blade
joint cutter
4.7 Connecting the cooling water
to the CF-2116 D
DANGER!
Danger of injury! Conversion and
connection of the cooling water supply
must only be done when the joint cutter is shut
down and the saw blade does not rotate.
DANGER!
Cutting operation has to be done in wet
cutting mode!
As per Employer’s Liability Insurance Association
cutting operations have to be carried out in wet cutting
mode to avoid hazardous dust.
ATTENTION!
Tools (diamond saw blades) designed
for wet cutting mode only must never
be operated without water. The tool’s lifetime will
decrease considerably and loss of segments will be
inevitable. Always assure sufcient water supply to
the saw blade.
In case of dust and stringy slurry increase the water
supply in order to cool the saw blade (segments)
sufciently and to rinse the cut (joint).
ATTENTION!
Only use water that is free of course
impurities (free of solids, clean) in order
to avoid blockage of the cooling system.
Do not use salt water!