Cellebrite UNIVERSAL FORENSIC EXTRACTION DEVICE Standard - UFED Power and Battery Options

Chapter 2 –UFED Configuration:
Ruggedized and Standard Versions
8 UFED System
2.5. Power and Battery Options
The UFED device can be powered by an AC power supply, a car power
supply, or by battery power. (NOTE: car power supply and battery pack
come with the Ruggedized Kit only.)
Battery Power
To run the UFED on battery power, flip the power switch to the right (“BAT”)
position. Battery power will take over.
Charging the Battery
To re-charge the battery, connect the device to an AC adapter (supplied with
the kit), and then flip the power switch to the left (“CHG”) position.
LED Indicator
The LED indicator provides input regarding the state of the UFED power:
Indication
LED Status
Red Battery charge in process
Green Battery fully charged
No light Sleep mode (no input power source) OR
No battery connected OR
Charge suspended (timer fault or thermal shutdown)
OR Over-voltage fault
Flashing Red
Indicates a problem with the battery. Verify that the
battery is connected properly.