8
Discover SP-D Clinical Installation
1. Place the Discover in a hood or on bench.
2. Plug the power cord into the back of the instrument.
3. Remove the vent tubing from the accessory kit and connect to the rear of the ActiVent.
4. Place the other end in the back of the fume hood or other location appropriate for solvent exposure.
5. Plug the power cord into the wall outlet.
6. To set up the air regulator:
a. Splice the tubing supplied by CEM in half.
b. Install one length of the tubing into the left side of the Discover by pushing in on the tubing
until resistance is felt.
c. Place the opposite end of the tubing into the regulator.
To Next Page
Loading...
