25
Logout
Once system operation is complete, the user can log out of the system. If the system is idle for 20 minutes or longer, the
system will automatically go into an idle mode and the user will be required to login to continue operation.
NOTE: “Logout” can be viewed by all user types (guest, standard, and administrator).
1. To logout, press the HOME key until the “Discover Home” screen appears.
2. Use the “+/-” keys to highlight “XXXX-Logout.”
NOTE: The username will appear where the “XXXX” is located.
3. Press the ENTER key to log out.
ActiVent Home, ActiVent Moving, ActiVent Closed, APM Recovery
There are four (4) different messages that can appear in the 3
rd
line of the Discover Home screen. Each message
describes the position of the ActiVent (APM).
NOTE: “ActiVent Home, ActiVent Moving, ActiVent Closed, APM Recovery” can be viewed by all user types (guest,
standard, and administrator).
• ActiVent Home is displayed when the attenuator is exposed and the APM is near the back of the instrument.
When “ActiVent Home” is highlighted and the ENTER key is pressed, the ActiVent will move to the closed
position. If a vessel is not in place when the ENTER key is pressed, the Discover SP-D Clinical will display a
“Vessel Not Found” message.
• ActiVent Moving is displayed when the ActiVent is either going to the home or closed position.
• ActiVent Closed is displayed when the ActiVent is positioned over the attenuator and the vessel is sealed. If
“ActiVent Closed” is highlighted and the ENTER key is pressed, the ActiVent will move to the home position.
• APM Recovery is displayed if the ActiVent is unable to find the home position. If “APM Recovery” appears, first
try to home the ActiVent. To home the ActiVent:
1. Use the “+/-” keys to highlight “APM Recovery”.
2. Press the ENTER key. A new screen will appear with the current error message.
3. Use the ARROW keys to highlight “APM Recovery”.
To Next Page
Loading...
Need help?
General
