TRMS AC/DC Low Current Clamp Meter
1
1. SAFETY INFORMATION
Do not operate the tester if the body of meter or the test lead
looks broken.
Check the main function dial and make sure it is at the correct
position before each measurement.
Do not perform resistance and continuity test on a live power
system.
Do not apply voltage between the test terminals and test
terminal to ground that exceed the maximum limit record in
this manual.
Keep the fingers behind the protection ring when measuring
through the test lead.
Change the battery when the
symbol appears to avoid
incorrect data.
Environmental Conditions
Operation Temperature:
0°C to 40°C (32°F to 104°F); < 80 % RH
Storage Temperature:
-10°C to 60°C (14°F to 140°F); < 80 % RH
Explanation Symbols
Attention refer to operation Instructions.
Dangerous voltage may be present at terminals.
This instrument has double insulation.
Approvals: EN61010 600V CAT III
To Next Page
Loading...
