COMMISSIONING BLOCK DIAGRAM
19
- Check correct motor direction (pg. 20)
- Select programme mode (pg. 21)
- Setting of gate limits (pg. 22-27)
NOTE: D3/D5 LIMITS ARE SET AUTOMATICALLY.
A5 LIMITS ARE SET MANUALLY
- Function Selections(optional) (pg. 27-28)
- Timer/counter settings (optional) (pg. 29-30)
Steps 1 to 3 must be done on initial commissioning.
Steps 4 & 5 are optional.
1
2
3
4
5
1 2
3 4 5
END
To Next Page
Loading...
