Centurion Vantage - V-Series Controller Specifications; Lightning Protection Details; Power Supply Information

page 12 www.CentSys.com
SECTION 3 SPECIFICATIONS
3.3. V-Series Controller
Maximum motor current per channel 15A (fused)
Maximum input voltage 14.4V DC
Standby current draw 48mA
Maximum solenoid current draw 2A DC
Maximum auxillary output current 3A (Resettable Electronic Fuse)
Collision detection Current sense and redundant-optical
Position and trajectory control Redundant optical
Temperature range -20°C to +60°C
Onboard receiver type Code-hopping multichannel
Receiver code storage capacity 64 transmitter buttons
Receiver frequency 433MHZ
TABLE 2
3.5. Power Supply
Nominal input voltage 90V - 240V AC ±10% @ 50/60Hz
AC current draw (maximum) 170mA
Temperature range -20°C to +60°C
Battery charger output current
(dependant on PSU input voltage)
90V AC input: 1.2A @ 13.8V
240V AC input: 1.8A @ 13.8V
TABLE 3
3.4. Lightning Protection
The V-Series Controller utilises the same proven surge protection philosophy that is
used in all our products. While this does not guarantee that the unit will not be damaged
in the event of a lightning strike or power surge, it greatly reduces the likelihood of
such damage occurring. The earth return for the surge protection is provided via the
mains power supply earth. In order to ensure that the surge protection is eective, it is
essential that the unit is properly earthed.