Centurion Vantage - Operator Installation - Inward Opening Gates; Step 1: Determine Installation Distances

page 27www.CentSys.com
SECTION 9
21. Solar Panel Wiring9. Operator Installation - Inward Opening Gates
OPERATOR INSTALLATION - INWARD OPENING GATES
Ensure that the gate mass does not exceed the specications on
page 14.
Figure 17 illustrates the values corresponding to the Inward Opening Gate Installation
Tables.
FIGURE 17. BRACKET POSITION - INWARD OPENING GATE
A
B
E
Wall
VANTAGE
operator
Gate in closed position
9.2. Step 1
Measure the E-Value and ensure that it does not exceed values shown in Figure 8 and
Table 10 on page 21.
Depending on the gate opening angle determined in Section 6.2 and the E-Value
measured, determine the installation distances for the A- and B-Value using the Tables
shown on pages 29 to 31.
9.1. Key terms used in this section
9.1.1. E-Value
The distance from the centre of the gate hinge to the edge of the pillar.
9.1.2. A-Value
The horizontal distance from the Wall Bracket/pivot pin to the center of the gate hinge.
9.1.3. B-Value
The vertical distance from the Wall Bracket/pivot pin to the center of the gate hinge.