3.5 Attaching Bent Towing Arm
Close the garage door.
Attach the Bent Towing Arm to the Towing Bracket (use the end of the arm which
has only one hole)
With the Drive Unit disengaged (Figure.12) position the Drive Unit in either one of
the following ways;
I. Adaptive Mode ~ any distance from the end of the Drive Rail.(Figure.11)
II. Manual Mode - 225mm from the end of the rail to the front of
the Drive Unit. (Figure.11)
Note: For an explanation of Adaptive and Manual Modes refer to section on
Obstruction Force on page 16.
Bring the Straight and Bent Towing Arms together and align the two furthest apart
sets of holes
Important Note: The two arms should be connected in a way that makes
them as long as possible.
Securely fix the arms together using two 8mm screws and nuts
3.6 Connecting to power supply
Plug the XTrac into a properly earthed 220 to 240V AC power outlet
Ensure that no excess power cord hangs below the Control Box
3.7 Engaging / Disengaging
The unique engage / disengage mechanism provides the following features:
a. Positive garage door locking even during power outages.
b. Re-engagement in any position without the need to line up chain and carriage
components.
Functionality
TO DISENGAGE - pull down on the release handle (Figure.12) until a click is “felt”
and then release the handle
TO ENGAGE - pull down on the release handle once again until a click is “felt” and
then release the handle
Page 13
To Next Page
Loading...
