IMPORTANT
Safety Instructions
ATTENTION
To ensure the safety of people, it is important that you read
all the following instructions. Incorrect installation or
incorrect use of the product could cause serious harm to
people.
The installer, being either professional or DIY, is the last
person on the site who can ensure that the operator is safely
installed, and that the whole system can be operated safely.
PLEASE READ CAREFULLY AND ADHERE TO ALL
SAFETY AND INSTALLATION RECOMMENDATIONS
The installation of your new Automatic Garage Door
Opener (herein after referred to as “XTrac”) must be
carried out by a technically qualified or licensed person.
Attempting to install or repair the XTrac without suitable
technical qualification may result in severe personal
injury, death and / or property damage
The XTrac must only be installed on a properly balanced
well functioning garage door. An improperly balanced or
malfunctioning garage door could cause serious personal
injury, death and / or property damage. Have a
qualified person check and if required, make repairs to
your garage door before installing the XTrac. The garage
door is deemed to be well balanced and aligned if it;
Requires an equivalent amount of applied force to
either manually open or no more than 150N (15kg) of
applied force to either manually open or close, and
Does not rise or fall more than 100mm when released
at any point between fully open or fully closed
positions
Does not rub on or incorrectly make contact with any
supporting or surrounding structures, and
The horizontal tracks have been installed level, and
The door panels have been installed level, and
The vertical tracks have been installed plumb, and
The junction between the curved horizontal track and
the vertical track does not cause the door to “jump”
The counterbalance springs on sectional type garage
doors must be properly lubricated between all of the coils
with heavy automotive bearing grease.
Page 1
To Next Page
Loading...
