Page 28
5.10 Wireless wall switch
The wireless wall switch provided with the XTrac kit provides ease of installation
without the need for running hard wires to the switch. It can be mounted in a
convenient location such as adjacent to a side entry door into the garage. The
four buttons provided on the wall switch are for independently operating from
one wall switch, the two openers of a double garage door installation. The
buttons can be used for activating the various function provided by the system.
Each individual button of the wall switch has been marked with a number, from one
to four, to help the user identify which function each button operates. For example,
it is easier to remember that Button One opens and closes the door, Button Two
activates the Courtesy Light, etc. The buttons can be learned in any configuration.
Mounting
The switch can be permanently screwed to the wall through the mounting holes
provided or alternatively “hooked” on the wall, providing the convenience of easy
demount ability, through the “hook” holes provided on the base plate
Use the mounting template and mounting instructions provided with the switch
The Wireless Wall Switch may be learned into be XTrac as per the procedure
outlined on Section 5.9 "Remote controls"
Important note: The wireless Wall Switch must be mounted within sight of
the garage door and a reasonable distance away from moving parts. It
should be mounted at least 1500mm above the ground and the Entrapment
Warning Label provided, must be attached adjacent to the switch.
5.11 Learn Button
The “Learn Button” (Figure. 19-D) is located within the Lamp Cover adjacent to
the “Learn LED” and serves to initiate the functions as described in the following
table:
5.12 LED Indicator
The LED Indicator (Figure.19-C) is located under the Courtesy Lamp Cover and
serves to indicate the functions as described in the following tables;
LED Display
Provides visual indication of functionality sequences as described in the following
table;
Display Indicator
Glow Solid Reached close limit position.
Slow Flash Reached open limit position.
Medium Flash Learning or deleting remote control codes
Quick Flash (A Mode) Learning new drive force parameters
Quick Flash (M Mode) Force adjust mode activated
Sleep Mode Intermittent Flash
Action
Momentary press
Press and hold for two seconds
Press and hold in conjunction with ”Run”
Button
Function
Learn remote control code
Formal Force Learning
Sleep Mode
To Next Page
Loading...
