Proceed this way to learn any other transmitter in the system to operate Function
One only. The system will remain in this learn mode for 10 seconds after the last
remote or wall pendant is learned and automatically exit after this time. The function
can be learned to any button, provided that the button has not yet been learned to
another function.
Function Two – Light
Learning a button to Function Two will enable that button to switch the Courtesy Light
on and off.
Operation
Momentarily press the associated transmitter button to either switch the courtesy
light on or off. If the light has been switched on, it will time out as per the maximum
current timer of 2 minutes.
Learning procedure
Press the Learn button TWICE to select Function Two Learn, if the operator is still in
Learn Mode, the Learn button need only be pressed once. the LED indicator will
flash twice every two seconds to confirm that Function Two Learn has been selected.
Take the remote control or wall pendant that must be learned into the system, press
and hold the desired button for three seconds. One long beep followed by two short
beeps will indicate that the button has been successfully learned into Function Two
and will activate the courtesy light upon being pressed. The system will remain in
this learn mode for 10 seconds after the last remote or wall pendant is learned and
automatically exit after this time. The function can be learned to any button,
provided that the button has not yet been learned to another function.
Function Three – Holiday Lockout
Learning a button to Function Three will enable that button to electronically lock the
controller for use. In other words, no transmitters or inputs will be able to trigger the
operator.
Operation
To engage Holiday Lockout Mode, the button learned to engage this function must be
pressed for three seconds before Holiday Lockout Mode will engage. The courtesy
light will emit a single flash and the onboard buzzer a single beep. When disengaging
Holiday Lockout Mode, a double flash and beep will indicate likewise. When the door
reaches the closed position, the courtesy light will remain in the ON state and time
out as per normal. Should a button which operates Function One other than any of
those associated with Holiday Lockout Mode be pressed whilst the operator is locked,
the onboard buzzer will emit a single beep.
The associated transmitter/wall pendant button must be pressed for three
seconds before the Holiday Lockout Mode will engage/disengage.
If the door is in the closed position, the lock will engage immediately.
However, if the door is in the open or partially open position, the door will
first close before engaging Holiday Lockout.
Learning procedure
Press the Learn button THREE times to select Function Three Learn. If the operator is
still in Learn Mode, the Learn button need only be pressed once. The LED indicator
will flash three times every two seconds to indicate that Function Three learn has
been selected. Take the remote control or wall pendant that must be learned into the
system and press and hold the desired button for three seconds. One long beep
followed by three short beeps will confirm that the button has been successfully
learned into Function Three, allowing activation of Holiday Lockout Mode as described
below. The system will remain in this learn mode for 10 seconds after the last remote
or wall pendant is learned and automatically exit after this time. The function can be
learned to any button, provided that the button has not yet been learned to another
function.
Page 26
To Next Page
Loading...
