Function Four – Autoclose Override
This function will allow the associated button to override the Autoclose function if it
has been selected, resulting in the door staying open.
Operation
The operation of this function is described as follows:
With the door in the closed position, the Autoclose Override button must
be pressed and held for at least three seconds to engage/activate this function
The light will flash quickly a number of times and simultaneously the
buzzer will emit multiple beeps to confirm the operation of this function
The door will also operate to open and stay open without Autoclosing
Pressing the open/close button will trigger the door to close
Learning procedure
Press the Learn button FOUR times to select Function Four Learn. If the operator is
still in Learn Mode, the Learn button need only be pressed once. The LED
i ndicator will flash four times every two seconds, indicating that Function Four
learn has been selected. To learn a button to this function, press and hold the
desired button for three seconds, after which one long beep followed by four short
beeps will sound. The system will remain in this learn mode for 10 seconds after
the last remote or wall pendant is learned and automatically exit after this time.
The button can be learned to any function, provided that the button has not yet
been learned to another function.
Function Five – All buttons
If Function Five is selected, all the buttons of a hand transmitter or wall pendant
will be learned in the following configuration:
Button 1 – Open/Close
Button 2 – Light
Button 3 – Lock
Button 4 – Autoclose override
Operation
The operation of Function Five will be according to the four different functions
described previously.
Learning procedure
Press the Learn button FIVE times to select Function Five Learn. The LED
indicator will flash rapidly and, after pressing a BUTTON THAT HAS NOT YET BEEN
ASSOCIATED WITH A FUNCTION, and keeping it pressed for three seconds, five
short beeps will sound. The system will remain in this learn mode for 10 seconds
after the last remote or wall pendant is learned and automatically exit after this
time. In the case of Function Five, the button number pressed will equal the
associated function number.
Code deleting
All remote control codes may be deleted as follows:
hinge open the Courtesy Lamp Cover to expose the ‘Learn’ Button (Figure.18)
momentarily press the ‘Learn’ Button (Figure.18-D) - LED Indicator
(Figure.18–C) will flash slowly
press and hold the black ‘Run’ Button - LED indicator will begin to rapid flash.
all remote control codes will have been deleted once the LED indicator ceases to
flash
close the Courtesy Lamp Cover
Page 27
To Next Page
Loading...
