Note: Mode will close out automatically after 10 minutes if not closed
out manually beforehand.
Safety Obstruction Force Adjustment – Open Direction
Hinge open the Lamp Cover (Figure.19-A) to expose the adjustment
controls
With the garage door in the fully closed position - press the black “Run”
Button (Figure.19-G) so that the garage door begins movement in the open
direction
As the garage door is opening slowly turn the (green) Open / Offset
Adjustment Pin (Figure.19-G) in an anti-clockwise direction until the garage
door stops
Now turn the same pin clockwise five degrees.
Testing Safety Obstruction Force – Open direction
With the garage door in the fully closed position - stand inside the garage
just behind the path of the garage door close to its middle position
Press the black “Run” Button (Figure.19-G) so that the garage door begins
to open
When the garage door has opened by approximately 450mm apply some
firm downward force to one of its structural members
If the Safety Obstruction Force Adjustment is correct the XTrac will stop
the garage door upon sensing the applied force
If too little or too much force is required to make the XTrac stop - rotate
the (green) Open / Offset Adjustment Pin five degrees in the appropriate
direction (clockwise to increase force, anti-clockwise to decrease force)
and then repeat the previous testing steps
Safety Obstruction Force Adjustment – Close direction
With the garage door in the fully open position, press the black “Run”
Button (Figure.19-F) so that the garage door begins to close
As the garage door is closing - slowly turn the (red) Close / Speed
Adjustment Pin (Figure.19-F) in an anti-clockwise direction until the garage
door stops and begins to Safety Reverse
Now turn the same pin clockwise five degrees
Testing Safety Obstruction Force – Close direction
With the garage door in the fully open position stand inside the garage
just behind the path of the garage door close to its middle position
Ensure that the Close Limit Travel Adjustment (Section.4.1) has been set so
that bottom of the garage door is resting firmly against the ground
Press the black “Run” Button so that the garage door begins to close
Place a 32mm thick block of wood under the line of the garage door
(approx at the midpoint of the garage door) so that the garage door will
close onto the block of wood.
If the Safety Obstruction Force Adjustment is correct the XTrac will stop
and reverse the direction of the garage door upon sensing the block of
wood
If the XTrac stops but does not reverse then turn the (red) Close / Speed
Adjustment Pin five degrees in an anti-clockwise direction. (Figure.19-F)
Page 19
To Next Page
Loading...
