Need help?Do you have a question about the Cetrek C-net 2000 MULTI and is the answer not in the manual?
General| Brand | Cetrek |
|---|---|
| Model | C-net 2000 MULTI |
| Category | Accessories |
| Language | English |
Describes the two versions (Coastal and Ocean) and various display modes.
Explains the initial power-up sequence and self-test routine.
Details how to adjust the LCD lighting brightness and contrast for optimal viewing.
Explains how to cycle through different data displays using soft keys.
Digital display and graph of the vessel's speed over the last two minutes.
Analogue gauge representation of the vessel's speed with a small digital display.
A digital display of speed using large characters.
Displays fastest and average speed since the unit was powered up or reset.
Shows trip and total distance and time for the vessel.
Countdown timer for races, which then counts up during the race.
Standard stopwatch functionality including start, stop, lap time, and reset.
Digital display and graph of the depth of water under the vessel.
Analogue gauge representation of depth with a small digital display.
A digital display of depth using large characters.
Displays deepest and average depth recorded since last reset.
Configuration and explanation of shallow, deep, and anchor alarms.
Displays two data windows, adjustable via grey keys.
A second display of two data windows, adjustable as above.
Displays four data windows, adjustable via grey keys.
A second display of four data windows, specific to Ocean versions.
Shows the 'Glide Path' view for approaching a waypoint.
Displays the vessel's current position, course, and speed.
Displays dead reckoning information for navigation assistance.
Shows the strength and direction of the tidal flow.
A basic plotter screen showing recent position history.
Analogue display showing live wind angle and speed.
Amplified scale for wind angle/speed, sensitive to course changes.
Summary of highest/average wind speed and angle.
Displays a 2-hour history of wind speed relative to Earth or ground.
A digital display of wind speed using large characters.
Configuration for high and low wind alarm thresholds.
Digital display of both wind angle and wind speed.
Large digital heading display with a tape repeater.
A digital display of heading using large characters.
Allows storing two tack angles and shows course change.
Steering compass with a moving pointer and digital readout.
Steering compass with a rotating card and digital readout.
Repeater function for a Cetrek Autopilot system.
Rudder angle indicator for a Cetrek Autopilot system.
Digital display and graph of water temperature.
Bulb thermometer representation of water temperature.
A digital display of temperature using large characters.
Displays highest, lowest, and average water temperature.
Digital display and graph of the supply voltage.
Pointer representation of the voltage with a small digital display.
A digital display of battery voltage using large characters.
Displays highest, lowest, and average battery voltage.
Setting display units for speed, depth, temperature, and distance.
Adjusting speed transducer, depth offset, and wind vane alignment.
Adjusting damping levels for readings that change too fast.
Choosing the system language from available options.
Enabling or disabling the audible feedback for key presses.
Setting display lighting levels for local control or group synchronization.
Overview of configuration settings, use with caution by trained personnel.
Masking NMEA messages on input channels to control data flow.
Selecting a demonstration display without connected transducers.
Resets all settings to default values; calibration data will be lost.
Copying software to other MULTI units via the CAN bus.
Provides diagnostic information and a useful NMEA viewer.
Details bulkhead and trunnion mounting methods for the instrument.
Explains cable routing, power supply, and NMEA data input connections.
Guidance on integrating a new unit into a CAN bus system.
Indicates when sensor data has not been received.
Indicates that sensor data has been lost.
Describes active alarm conditions and how to clear them.
Details the audible alerts for the race timer countdown.
Lists the NMEA 0183 (version 2) messages read, combined, and output.
Lists the two proprietary messages used by the system.
To Next Page