79
GB
installation
Positioning
The device detects the room temperature,
therefore several factors should be taken
into account when choosing an installation
site.
Keep it away from sources of heat (radiators,
sunlight, fi replaces, etc.) and from draughts,
doorways and windows which could affect
the temperature readings.
It should be installed approximately 1.50
metres above the fl oor level.
Warning
Installation should be performed by a
qualifi ed technician.
Before fi tting the appliance, make sure
the electricity supply is not connected.
Wall installation
The Expert Control system interface must
be fi tted to the wall before the BUS line is
connected.
- connect the pair of wires to the connector
(fi g. 1);
- open up the holes required for fi xing;
- fi x the base of the device to the box on
the wall using the screws supplied in the
kit (fi g. 2);
- position the system interface on the base,
pushing it gently downwards (fi g. 3).
fi g. 1
fi g. 2
fi g. 3
B T
BUS
B T
To Next Page
Loading...
Need help?
General
