79028569 A Rev. 01-1
Introduction
INTRODUCTION
INTRODUCTION
The purpose of this manual is to assist dealers and
distributors in the efficient repair and maintenance of farm
machinery. Carrying out the procedures as detailed,
together with the use of special tools where appropriate
will enable the operations to be completed within the time
stated in the repair time schedule.
NOTE: To assist with location information, each division
of the manual is proceeded by a contents page
listing the operations in numerical order.
Each instruction within an operation has a sequence
number, and to complete the operation in the minimum
time it is essential that these instructions are performed in
numerical sequence commencing at 1 unless otherwise
stated. When applicable, these sequence numbers
identify the components in the appropriate illustration.
Where performance of an operation requires the use of a
special tool. The tool is called out in that operation.
Indexing
For convenience, the manual is divided into parts,
sections and sub-sections with each page number
bearing the part and section number. Page numbers are
located at top outside of each page. Beneath the page
number is written title of manual division
Page number example: 01-15
Division 01, page 15
This simplifies cross-referencing and enables the subject
to be found easily.
NOTE: Page numbers will be consecutive within each
sub-section. A void of page numbers may be
used between these sub-sections in order to
provide space for future amendments and also to
indicate the beginning/end of adjustments and
also to indicate the beginning/end of adjacent
sub-sections.
Special Tools
Where the use of a special tool is specified in an
operation, the tool will be called out.
The use of the special tools mentioned in the text
contributes to a safe, efficient and profitable repair. Some
operations are impracticable without their use.
Make certain proper tools are available when starting the
job.
Repair and Replacements
When service parts are required, it is essential that only
genuine AGCO / Challenger / Massey Ferguson
replacements are used.
• Attention is particularly drawn to the following points
concerning repairs and the fitting of replacement
parts accessories:
• Safety features embodied in the tractor may be
impaired if other than genuine parts are fitted.
• In certain territories, legislation prohibits the fitting of
parts not to the tractor manufacturer's specification.
• Torque wrench setting figures given in the Workshop
manual must be strictly adhered to.
• Locking devices where specified must be fitted. If the
efficiency of a locking device is impaired during
removal it must be renewed.
• The tractor warranty may be invalidated by the fitting
of other than genuine AGCO / Challenger / Massey
Ferguson parts. All replacements have the full
backing of the manufacturers warranty. AGCO /
Challenger / Massey Ferguson Distributors and
Dealers are obliged to supply only genuine service
parts.
Repair Time Schedule
The operation listed in the Repair Time Schedule refer to
those described in this manual. The time set against each
operation in the schedule is established by performing the
actual operation standard machines using special tools
where applicable. The Repair Time Schedule for use with
this manual is issued as a separate publication.
NOTE: Repair Time Schedules are issued to Challenger
/ Massey Ferguson Distributors and Dealers only
and are not for general publication.
Find manuals at https://best-manuals.com
To Next Page
Loading...
Need help?
General
