What to do if my Chamberlain RSL12VDC shows CLOSE EDGE triggered, causing reversal, preventing close, or cancelling TTC (main board)?
If an obstruction occurred, no action is required. If an obstruction did NOT occur, check the alignment, inputs, and wiring.
What to do if my Chamberlain Gate Opener shows CLOSE EYE/INTERRUPT triggered, causing reversal, preventing close, or resetting TTC (main board)?
If an obstruction occurred, no action is required. If an obstruction did NOT occur, check the alignment, inputs, and wiring.
What does it mean if my Chamberlain Gate Opener shows CLOSE EDGE held more than 3 minutes (main board)?
Check the CLOSE EDGE input on the main board and check for alignment or obstruction.
What to do if my Chamberlain Gate Opener's control board has experienced an internal failure?
Disconnect all power, wait 15 seconds, then reconnect power (reboot). If the issue continues, replace the control board.
How to troubleshoot a Chamberlain RSL12VDC Max-Run-Time Exceeded Error?
Check for any obstructions, and then reprogram the limits.
What to do if my Chamberlain RSL12VDC experiences an Absolute Position Encoder Error?
Check the operator cable connections, and then reprogram the limits.
What to do if my Chamberlain RSL12VDC Gate Opener shows Wireless edge loss of monitoring?
Check the wireless edge inputs.
What to do if my Chamberlain RSL12VDC experiences a Brownout?
A brownout occurs when the AC/DC board supply dips below the allowable level. Review the power supply and wiring. If rebooting, ensure enough time for discharge of power to force a fresh boot.
What to do if my Chamberlain Gate Opener shows a Product ID Error?
If the control board was just replaced, erase the limits, enter limit setup mode, and set the limits. Otherwise, disconnect all power, wait 15 seconds, then reconnect power before changing the product ID harness.
How to fix a Chamberlain RSL12VDC Run-Distance Error?
A Run-Distance Error can be caused by gate unbalance. Make sure the gate is installed on a level surface and not on an excessive grade.
General| Power Source | 12V DC |
|---|---|
| Control Options | Remote control, Keypad (optional) |
| Control Type | Remote Control |
| Safety Features | manual release |
| Motor Type | DC Motor |
| Installation | DIY |
| Type | Slide Gate Opener |
To Next Page