What to do if my Chamberlain RSL12VDC experiences RPM / STALL Reversal?
Check for any obstructions. If no obstruction is present, check the operator cable wiring and ensure the operator arm is engaged and free to move. If necessary, replace the operator arm.
What does it mean when my Chamberlain RSL12VDC Gate Opener shows Wireless edge triggered?
If an obstruction occurred, no action is required. However, if an obstruction did NOT occur, check the inputs and wiring.
What to do if my Chamberlain RSL12VDC experiences a Force reversal?
Check for any obstructions. If no obstruction is found, verify that the operator arm is engaged and free to move.
What to do if my Chamberlain RSL12VDC Gate Opener has a battery shorted?
Check the battery harness for a short to the chassis.
What to do if my Chamberlain RSL12VDC has no battery at boot up?
Check the battery connections and installation. If the batteries are depleted to less than 20V on a 24V system, replace them. Also, ensure you do NOT have a single 12V battery on a 24V system.
What to do if my Chamberlain RSL12VDC shows battery overcurrent?
A battery overcurrent can be triggered by a possible short of the battery charge harness. Check the harness and ensure you do NOT have a 12V battery on a 24V system.
Why is my Chamberlain RSL12VDC Gate Opener battery overvoltage?
The battery overvoltage may be due to too much voltage on the battery. Check the harness and ensure you do NOT have a 24V battery on a 12V system.
General| Power Source | 12V DC |
|---|---|
| Control Options | Remote control, Keypad (optional) |
| Control Type | Remote Control |
| Safety Features | manual release |
| Motor Type | DC Motor |
| Installation | DIY |
| Type | Slide Gate Opener |
To Next Page