37
Troubleshooting ::
If you’re manually updating your DVR+ software using a USB
flash-memory drive, you may see one of the following messages
displayed after inserting the drive into a USB port:
• “EHD Insufficient Disk Size” – Some flash-memory drives have
multiple small partitions, or even zero partitions. Try reformatting
the drive to have a single primary partition, or use a different
flash drive.
• “A USB download has been detected which is already present on
your device.” – Your DVR+ receiver has been updated to the same
version of software as you have on the flash drive. It’s up-to-date,
so no further update is needed.
• “I changed the channel and a Locked Channel message is
displaying requesting the PIN (password).” Parental Control has
been activated and the channel has been locked. See page 28.
• “I changed the channel and a Parental Lock Activated or Rating
Locked message is displaying requesting the PIN (password).”
The program or event currently on this channel has been locked.
See page 28.
• “I chose a program or event in the guide and a message is
displayed requesting a PIN (password).” Parental Control has
been activated and the channel or the program or event has been
locked. See page 28.
Software Update
Issues
Parental Control
Issues
To Next Page
Loading...
