Channel Master DVR+ - Programming the Remote Control

10
:: Getting Started
Easy Scan Programming Method 1
If your brand of TV or audio device is listed in the table below in
step 4, follow this procedure to program your remote. You can
program only one device at a time.
1 Turn on your TV or audio device.
2 Press and hold the SETUP button until the OFF/ON button
fl ashes twice, then release the button.
3 To program the remote to control your TV, press the
Red (TV) button. Or, to program the remote to control your
audio device, press the Green (AUD) button. The OFF/ON
button turns red.
4 In the table to the right, locate the number that’s associated
with your device (e.g., #8 if you have a Sony TV).
5 Point the remote at the TV or audio device you want to
program. Using the numeric keypad, hold down the button
corresponding to the number in the table for your device.
6 When your TV or audio device turns off, immediately release
the button. The OFF/ON button fl ashes twice to indicate that
the code has been programmed successfully for your TV or
audio device.
7 Point the remote toward the device and press the ON button
to power on your device and confi rm that the remote now
controls your device.
Button
Number
TV Audio
1 Insignia Bose
2 LG Denon
3 Mitsubishi LG
4 Panasonic Onkyo
5
Philips/
Magnavox
Panasonic
6
Samsung
(default)
Philips
7 Sharp Pioneer
8 Sony Samsung
9 Toshiba Sony
0 Vizio Yamaha
The remote is capable of controlling basic functions of most TVs and audio devices (volume, mute,
power, input). To program the remote control to operate your TV or audio device, you may use the
Easy Scan or Code Entry methods described on the following pages.
Note 1: The OFF/ON button is actually two controls: The left side is OFF and the right side is ON.
Note 2: If you wait more than 10 seconds between any step in this programming procedure, the
setup will time out and you’ll need to restart the procedure.
or
SETUP
ON
Programming the Remote Control