RSR-000886-000 (1) Page 17 of 40
When wrapping the hand piece fiber around the fiber manager spool, the first fiber wrap
should be fed into the Fiber Slot so the plastic Bifurcator, which couples the finger switch
and fiber optic cables, snaps into the slot. Five more wraps (for a total of six) should be
made tightly around the spool to provide enough length for the hand piece to feed into the
Hand Piece Clip (Figure 20).
3.7. Laser Safety Eyewear
Warning: ALWAYS wear the protective eyewear supplied with this laser system
when operating the device.
Additional protective eyewear can be purchased from company webstore.
Warning: All personnel who are in the laser treatment controlled area MUST wear
laser safety eyewear.
Warning: DO NOT remove protective eyewear until the operator returns the laser
device to Standby mode.
Warning: If you suspect injury, such as direct exposure to the eyes, seek medical
attention immediately.
3.8. Medical Grade Power Cord
Caution: Do not use any power cord other than the one provided with the system.
If a replacement is needed, additional power cords can be purchased from the company
webstore.
Piece
To Next Page
Loading...
