RSR-000886-000 (1) Page 26 of 40
5. Maintenance
Warning: DO NOT attempt to gain access to any internal component. Doing so may
cause serious and/or irreversible injury. THERE ARE NO USER-SERVICEABLE
COMPONENTS inside this laser device.
5.1. Cleaning
Warning: It is recommended to always turn off the laser system and unplug the power
cord from the wall outlet before cleaning the system.
Warning: Always use protective eyewear and gloves when cleaning and disinfecting
any equipment.
Warning: Clean the contact treatment heads (large massage ball and small massage
ball) between treatments to prevent cross-contamination and infections.
Warning: DO NOT use a treatment head immediately after cleaning with alcohol
solution. Wait until the solution used in the cleaning procedure completely
evaporates. Not allowing it to dry may cause the laser to ignite alcohol solutions or
vapors.
Caution: DO NOT clean the lens inside the hand piece. Doing so may damage the
lens during laser emission.
5.1.1. Cleaning the Console
Step 1. Before cleaning the console, turn off the laser system and unplug the power
cord from the wall outlet.
Step 2. The exterior surfaces on the unit and treatment heads can be cleaned by wiping
with a soft, non-fibrous wipe (e.g., Kimwipes
®
) moistened with isopropyl alcohol
solution.
• Ensure the solution is only 70% alcohol. Solutions of more than 70%
alcohol can cause product damage.
• Avoid using soiled or gritty cloths.
Step 3. After cleaning, ensure that all cleansers have been removed and the parts are
dry before use.
Note: The laser system uses solid-state laser technology. It is important to keep the unit
and accessories free from dust.
To Next Page
Loading...
