Configuring Through a Web Browser
CHCNAV i90 GNSS USER GUIDE | 2019-9 P a g e | 51
For Reference Latitude and Reference Longitude:
There are mainly three methods to enter the reference coordinates and shown as follows:
a) Acquire Current Position: Click this button to acquire current position obtained
through autonomous positioning automatically.
b) Manual Input: Manually input the coordinate of a control point.
c) From CORS: After the receiver logging in CORS, the software can record the coordinate
of current position based on fix solution.
For Sample for Average:
Users can determine the positioning limit and sampling amount. The positioning limit falls into
two types:
a) Single Solution Coordinates: Collect the coordinates of receiver obtained through
autonomous positioning.
b) Fixed Solution Coordinates: Only collect coordinates of receiver with a fixed solution.
After the configuration of positioning limit and sampling amount, click to carry out
sampling and averaging → the progress bar will show the progress → the result will be served
as the coordinate of current position.
If users need to save the changes, please tap button.
5.3.4 Receiver Reset Submenu
Use this screen to completely or partially reset the receiver:
To Next Page
Loading...
