CHERUBINI TDS COMPACT - Function Open;Close Programming (Skipper;Giro Series); Checking Function Status; Enabling Programming; Disabling Programming

27
FUNCTION OPEN/CLOSE PROGRAMMING
REMOTE CONTROL SKIPPER - GIRO SERIES
To prevent accidental changes to the programming of the motor during the daily use of
the remote control, the possibility of programming is disabled automatically 8 hours after
sending the last sequence (A+B or B+C).
CHECKING THE STATUS OF THE FUNCTION
To change the status of the function, see the sequences “ENABLE/DISABLE
PROGRAMMING”
Proceed with programming as the instructions booklet
ENABLE PROGRAMMING
DISABLE PROGRAMMING
ON
Open
programming
Closed
programming
....
ON
....
....
Closed
Open
ON
or after
30 sec.
or after
30 sec.
1 2 3
OPTION 1
1 2 3
1 2 3
or after
30 sec.
+ +
A B
C
B
B
C
+ +
A B
C
+ +
A B
C
A
B
Tn
Tn
Tn
OPTION 2
OPTION 2
OPTION 2
OPTION 2
Remove a battery
and wait 5 seconds,
or press any button.
2 sec
B
ENGLISH