1
Position Base in forward facing vehicle
seat with Recline Foot against seat back.
2
Adjust Base Angle by pushing Recline
Buttons while lifting Base. Angle is correct
when Bubble is between arrows.
Vehicle must be on a level surface for
the Bubble to indicate correctly.
3
Route Vehicle Belt through openings
in Base and buckle the vehicle belt.
4
Tighten Vehicle Belt while pushing
Base rmly into vehicle seat.
5
Secure Vehicle Shoulder Belt rmly
under Shoulder Belt Lockoff, while keeping
tension on Belt.
1
INSTALLATION USING VEHICLE BELT
UAS or Vehicle Belt? This Infant restraint system can
be safely installed using Vehicle Belts or UAS.
Use the method that results in the MOST
SECURE installation in your vehicle.
2
3
4
5
To Next Page
Loading...
