Chicco KEYFIT - INSTALLATION IN AIRCRAFT; Aircraft Installation Steps; Aircraft Use and Airline Policies

38
39
INSTALLATION IN AIRCRAFT
1
Position Carrier rear facing in aircraft
seat, with infant properly secured in Carrier.
2
Move Carrier Seat Pad to expose Belt
Guides.
3
Route Aircraft Lap Belt under both
Belt Guides, and fasten the aircraft belt.
4
Tighten Aircraft Lap Belt while
pushing Carrier rmly into
aircraft seat.
A tightly rolled airline blanket may be
used under the front edge of the Carrier
if needed for stable, secure installation.
5
Check Installation:
a
Level Line on Carrier MUST
be LEVEL with ground.
b
Aircraft belt MUST be TIGHT.
c
Carrier MUST be STABLE
and secure.
This Infant restraint system is certied for use in commercial aircraft. Be
sure to contact your airline prior to travel, to discuss their Infant restraint
system policy.
a
b
2 3
4 5
Cannot be used with base in
an aircraft.