Chicco KEYFIT - INSTALLATION WITHOUT BASE; Belt Installation Procedure

36
37
a a
INSTALLATION WITHOUT BASE
1
Position Carrier rear facing on vehicle
seat, with infant properly secured in
Carrier.
2
Move Carrier Seat Pad to expose Belt
Guides.
3
Route Vehicle Belt under both Belt
Guides, and buckle the vehicle belt.
4
Tighten Vehicle Belt while pushing
Carrier rmly into
vehicle seat.
A tightly rolled towel may be used
under the front edge of the Carrier if
needed for stable, secure installation.
5
Check Installation:
a
Level Line on Carrier MUST
be LEVEL with ground.
b
Vehicle belt MUST be TIGHT.
c
Carrier MUST be STABLE
and secure.
NEVER install Carrier without Base using a non-locking ELR vehicle belt.
The installation will NOT be secure. Refer to your vehicle owner’s manual for
detailed vehicle belt information.
a
b
2 3
4 5