Chicco KEYFIT - INSTALLATION USING UAS - FINAL STEPS; UAS Belt Tightening and Storage; UAS Installation Verification

34
35
5
Tighten UAS Belts by pulling up rmly
on UAS Pull Strap while pressing Base
rmly into vehicle seat.
6
Store UAS Pull Strap neatly
in Pull Strap Storage Pocket.
7
Check Installation
a
UAS belts MUST be
TIGHT
b
Base MUST be STABLE
c
Bubble MUST be
between arrows
d
UAS Pull Strap MUST
NOT interfere with
attachment of Carrier
to Base.
8
Attach Carrier to Base after properly
securing infant in Carrier. Lift up on Carrier
to verify it is properly attached to the Base.
8
5
7
6
INSTALLATION USING UAS