Step 2：Select “Specify an IP address” and enter “192.168.168.xxx” (the default value of 480 is
192.168.168.125) in the “IP Address” location (where xxx is a number between 1 and 254 used
by the High-Performance BF-480 to identify each computer), and the default “Subnet Mask”
“255.255.255.0”. Note that no two computers on the same LAN can have the same IP address.
Click “OK”. to complete the TCP/IP installation.
2.3.3 Configure your BF-480
Step 1：Open your web browser and type http://192.168.168.125 in the browser’s address box.
This address is the factory set IP Address of your BF-480. Press “Enter”.
Step 2：The “Username and Password required” prompt box will appear. Typing “admin”
(default username) in the Username field and typing “admin” (default password) in the Password
field. Click “OK”. The setup screen will then appear.
To Next Page