KEY FOB
This feature allows the driver to operate the ignition switch with the push of a button as long as the
Remote Keyless Entry (RKE) transmitter is in the passenger compartment.
The Keyless Push Button Ignition has four operating positions, three of which are labeled and will
illuminate when in position. The three positions are OFF, ACC, and ON/RUN. The fourth
position is START. During start, RUN will illuminate.
NOTE:
In case the ignition switch does not change with
the push of a button, the RKE transmitter (Key
Fob) may have a low or dead battery. In this
situation, a back up method can be used to
operate the ignition switch. Put the nose side
(side opposite of the emergency key) of the
Key Fob against the ENGINE START/STOP
button and push to operate the ignition switch.
Locking And Unlocking The Doors
Push and release the LOCK button on the
RKE transmitter to lock all doors. The turn
signal lights will flash, and the horn will chirp to
acknowledge the signal.
Push and release the UNLOCK
button on
the RKE transmitter once to unlock the driver's
door or twice within five seconds to unlock all
doors. The turn signal lights will flash to ac-
knowledge the unlock signal. The illuminated
entry system will also turn on.
1st Press Of Key Fob Unlocks
This feature lets you program the system to unlock either the driver's door or all doors on the first
push of the UNLOCK button on the RKE transmitter. To change the current setting, refer to your
“Uconnect Settings” in “Understanding Your Instrument Panel” in your Owner's Manual on the
DVD for further information.
Key Fob
1 — Trunk Release
2 — Unlock Door(s)
3 — Lock Door(s)
4 — Remote Start
5 — Panic Alarm
GETTING STARTED
10
To Next Page
Loading...
