Rear Head Restraints
The rear outboard head restraints have three positions Up, Mid and Down. The center head
restraint has only two positions, Up and Down. When the center seat is being occupied the head
restraint should be in the raised position. When there is no occupant in the center seat, the head
restraint can be lowered for maximum visibility for the driver.
To raise the head restraint, pull upward on the head restraint. To lower the head restraint, push the
ad justment button, located at the base of the head restraint, and push downward on the head
restraint.
NOTE:
To remove the head restraint, raise it as far as it can go then push the release button and the
ad justment button at the base of each post while pulling the head restraint up. To reinstall the
head restraint, put the head restraint posts into the holes and push downward. Then adjust the
head restraint to the appropriate height.
WARNING!
ALL the head restraints MUST be reinstalled in the vehicle to properly protect the occupants.
Follow the re-installation instructions above prior to operating the vehicle or occupying a seat.
FRONT SEATS
Power Seats — If Equipped
Some models may be equipped with a power driver's seat. The power seat switch is located on
the outboard side of the seat near the floor. Use the switch to move the seat up, down, forward or
rearward.
Adjusting The Seat Forward Or Rear-
ward
The seat can be adjusted both forward and
rearward. Push the seat switch forward or rear-
ward. The seat will move in the direction of the
switch. Release the switch when the desired
position has been reached.
Adjusting The Seat Up Or Down
The height of the seats can be adjusted up or
down. Pull upward or push downward on the
seat switch. The seat will move in the direction
of the switch. Release the switch when the de-
sired position is reached.
Power Seat Switches
1 — Power Seat Switch
2 — Recline Switch
3 — Power Lumbar Switch
GETTING STARTED
31
To Next Page
Loading...
