Audio
Push the AUDIO button on the radio faceplate.
The Audio Menu shows the following options for you to customize your audio settings.
Treble, Mid, Bass, Fade, Balance, Speed Adjusted Volume, Loudness Select the desired
setting to adjust, then push the ENTER/BROWSE button. Turn the TUNE/SCROLL knob to
ad just the setting + or - 9. Push the “Back” button when done.
Radio Operation
Seek Up/Down Buttons
• Push the up or down button to seek through radio stations in AM, FM or SXM bands.
• Hold either button to bypass stations without stopping.
Store Radio Presets Manually
The Presets are available for all Radio Modes, and are activated by pushing any of the six Preset
buttons. The Radio stores up to 18 presets in each of the Radio modes. Push the A-B-C button
on the faceplate to select the A, B or C preset list.
To store a radio preset manually, follow the steps below:
1. Tune to the desired station.
2. Push and hold the desired numbered button for more than two seconds, or until you hear a
confirmation beep.
USB/Audio Jack (AUX ) Operation
To select a specific audio source, push the MEDIA button on the faceplate and select from the
following modes:
USB/iPod
• USB/iPod Mode is entered by either inserting a USB Jump Drive or iPod cable into the USB
port or by pushing the MEDIA button located left of the display.
Audio Jack (AUX)
• The AUX allows a portable device such as an MP3 player or an iPod to be plugged into the
radio and utilize the vehicle’s audio system, using a 3.5 mm audio cable, to amplify the source
and play through the vehicle’s speakers.
• The functions of the portable device are controlled using the device buttons, not the buttons
on the radio. The volume may be controlled using the radio or portable device.
ELECTRONICS
88
To Next Page
Loading...
