Tilting The Seat Up Or Down
The angle of the seat cushion can be ad justed up or down. Pull upward or push downward on the
front of the seat switch. The front of the seat cushion will move in the direction of the switch.
Release the switch when the desired position has been reached.
Reclining The Seatback Forward Or Rearward
The seatback can be reclined both forward and rearward. Push the seat recliner switch forward or
rearward. The seatback will move in the direction of the switch. Release the switch when the
desired position has been reached.
WARNING!
Do not ride with the seatback reclined so that the shoulder belt is no longer resting against
your chest. In a collision you could slide under the seat belt, which could result in serious injury
or death.
Power Lumbar — If Equipped
Vehicles equipped with power driver’s seat may be equipped with power lumbar. The power
lumbar switch is located on the outboard side of the power seat. Push the switch forward or
rearward to increase or decrease the lumbar support. Push the switch upward or downward to
raise or lower the lumbar support.
Memory Seat
The memory seat feature allows you to set two different driver seating positions, driver's outside
mirror, and radio station preset settings. The memory seat buttons are located on the driver's
door panel.
To set a memory position:
1. Cycle the vehicles ignition to the ON posi-
tion.
2. Adjust all memory profile settings.
3. Push the S (SET) button then push the 1 or
2 button within five seconds. The Electronic
Vehicle Information Center (EVIC) or
Driver Information Display (DID) will dis-
play which memory position is being set.
NOTE:
Before programming your RKE transmitters you must select the “Personal Settings Linked To
Fob” feature through the Uconnect system. Refer to “Uconnect Settings ” in “Understanding
Your Instrument Panel” in the Owner's Manual on the DVD for further details.
To program a Key Fob to the memory position:
1. Cycle the vehicles ignition to the OFF position.
Memory Seat Buttons
GETTING STARTED
32
To Next Page
Loading...
