PARKVIEW REAR BACK UP CAMERA
Your vehicle may be equipped with the ParkView Rear Back Up Camera that allows you to see an
on-screen image of the rear surroundings of your vehicle whenever the shift lever is put into
REVERSE. The image will be displayed on the touchscreen display along with a caution note to
“check entire surroundings” across the top of the screen. After five seconds this note will
disappear. The ParkView camera is located on the rear of the vehicle above the rear license plate.
NOTE:
The ParkView Rear Back Up Camera has programmable modes of operation that may be
selected through the Uconnect System. Refer to “Uconnect Settings” in “Understanding Your
Instrument Panel” in the Owner’s Manual on the DVD for further information.
When the vehicle is shifted out of REVERSE (with camera delay turned OFF), the rear camera
mode is exited and the navigation or audio screen appears again.
When the vehicle is shifted out of REVERSE (with camera delay turned ON), the camera image
will continue to be displayed for up to 10 seconds after shifting out of REVERSE unless the
vehicle speed exceeds 8 mph (13 km/h), the vehicle is shifted into PARK or the ignition is
switched to the OFF position.
A touch screen button to disable display of the camera image is made available when the vehicle
is not in REVERSE gear. Display of the camera image after shifting out of REVERSE can be
disabled via a touch screen button personalization entry in the camera settings menu.
When enabled, active guide lines are overlaid on the image to illustrate the width of the vehicle
and its projected backup path based on the steering wheel position.
When enabled, fixed guide lines are overlaid on the image to illustrate the width of the vehicle.
Different colored zones indicate the distance to the rear of the vehicle.
NOTE:
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the lens, rinse with
water, and dry with a soft cloth. Do not cover the lens.
OPERATING YOUR VEHICLE
65
To Next Page
Loading...
