1. Remove the jack, wheel bolt wrench and wheel chocks from the spare wheel as an assembly.
Remove the chocks from the jack assembly.
NOTE:
The jack handle attaches to the side of the
jack with two attachment points. When the
jack is partially expanded, the tension be-
tween the two attachment points holds the
jack handle in place.
2. Chock both the front and rear of the wheel
diagonally opposite of the jacking position.
For example, if changing the right front tire,
chock the left rear wheel. Place both chocks
under the tire.
3. If equipped with aluminum wheels where
the center cap covers the wheel bolts, use
the wheel bolt wrench to pry the center cap
off carefully before raising the vehicle.
4. Before raising the vehicle, use the wheel bolt wrench to loosen, but not remove, the wheel
bolts on the wheel with the flat tire. Turn the wheel bolts counterclockwise one turn while the
wheel is still on the ground.
Jack And Tools
WHAT TO DO IN EMERGENCIES
165
To Next Page
Loading...
