Chrysler PACIFICA 2017 - Battery Saver On;Battery Saver Mode Message - Electrical Load Reduction Actions - if Equipped

Instrument Cluster Display Screen Setup Options:
4 — Odometer
• Show
• Hide (Odometer will still appear when door is open)
5 — Defaults • Restore
• Cancel
Speed Warning — If Equipped
Push and release the up or down arrow button until Speed
Warning is highlighted in the instrument cluster display.
Push and release the OK button to enter speed warning.
Use the up or down arrow button to turn the speed
warning ON or OFF, then push and release the OK button
to confirm the selection. If the ON status is selected, use the
up or down arrow button to set the desired speed, then
push the OK button to set the speed for the speed warning.
A speed warning telltale will illuminate in the instrument
cluster, with a number matching the set speed, with a pop
up message to inform the driver that the speed warning
has been set to the desired speed. Each time the set speed
is exceeded more than 2 mph (3 km/h), an audible chime
will sound for up to 10 seconds, or until the speed is no
longer exceeded. The telltale in the instrument cluster will
also change from white to yellow, and a pop up warning
message will pop up on the instrument cluster display.
NOTE: Speed Warning is unavailable while KeySense is in
use.
Battery Saver On/Battery Saver Mode Message —
Electrical Load Reduction Actions — If Equipped
This vehicle is equipped with an Intelligent Battery Sensor
(IBS) to perform additional monitoring of the electrical
system and status of the vehicle battery.
In cases when the IBS detects charging system failure, or
the vehicle battery conditions are deteriorating, electrical
load reduction actions will take place to extend the driving
time and distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical loads.
Load reduction is only active when the engine is running.
It will display a message if there is a risk of battery
depletion to the point where the vehicle may stall due to
lack of electrical supply, or will not restart after the current
drive cycle.
194 GETTING TO KNOW YOUR INSTRUMENT PANEL