CIAT V3000 KNX - Deconfiguring Master;Slave Loop

2 - Case of a Master unit with several slaves:
- 1 master must be associated with 1 slave only
- This must therefore be repeated as many times as there are slaves
- Perform the same operation as in paragraph 1 with the first slave .
- Do the same operation as in paragraph 1 with all other slaves associated with this mastere.
- Starting from the 2nd slave configuration lasts 30 seconds to 1 minute
Note: Allow a maximum of 15 slaves for 1 master unit.
3 - Verify configuration via diagnostics d01 and d02
- d01 relates to the master
- d01 gives the address of the master on the bus, for instance: 1
- d02 relates to the slave
- d02 enables you to check which master is associated with the queried slave. All slaves with their d02 at 1 are associated
with master no.1.
Deconfiguring a Master/Slave loop
a)
Start with the slave
- To switch to configurator mode, press buttons for 5 seconds.
- Press
for 5 seconds until the display "dEL" flashes.
b)
Go on to the master
- Perform the same operation as above
c) Configuration takes between 30 seconds and 1 min (approximately). It is completely finished when "dEL
0
" goes back to
being fixed.
d) To return to normal display, press
e) If the display "Err" appears, an error has occurred
Check:
- The bus wiring
- Its power supply
- Parameter P00 on the master and slave
and restart the operation
Configuration on SLAVE on MASTER
Step 1
- Access the "CnF" menu on the Slave
/ for 5 s
witch the Slave to deconfiguration
-
for 5 s
- "dEL" flashes
Step 2
- Access the "CnF" menu on the Master
/ for 5 s
Switch the Master to deconfiguration
-
for 5 s
- "dEL" flashes
Step 3 Wait 30 s to 1 min
"dEL
6
"
flashes
"dEL
4
"
flashes
Step 4 End of deconfiguration if:
"dEL
0
"
Fixed display
"dEL
0
"
Fixed display
Step 5 Deconfiguration successful
Button
to exit CnF menu
EN
EN - 15 EN7515935-00