Need help?Do you have a question about the CIAT V3000 KNX and is the answer not in the manual?
General| Brand | CIAT |
|---|---|
| Model | V3000 KNX |
| Category | Control Unit |
| Language | English |
Details the features and information displayed on the terminal screen.
Describes the features and operation of the wireless remote control.
Explains the characteristics of flush-mounted and dial type terminals.
Details the functions of various buttons and the temperature adjustment dial.
Explains the meaning of various indicator lights on the terminals.
Provides a detailed breakdown of elements shown on the display screen.
Lists and explains special indications or messages shown on the display.
Explains the various symbols used in the display and their corresponding meanings.
Instructions on how to enter and modify installation parameters.
Lists and describes installation parameters from P00 to P14.
Lists and describes installation parameters from P24 to P52.
Lists and describes installation parameters from P55 to P96.
Procedure to access the diagnostic functions of the controller.
Lists and explains initial diagnostic codes.
Lists and explains further diagnostic codes for system monitoring.
Details alarm codes and their corresponding descriptions.
Addresses common problems related to the user terminal.
Covers typical problems encountered with the fan coil unit.
Explains how to resolve faults and manage alarm conditions.
Relates parameter P24 to air temperature sensor selection and diagnostics.
Discusses optimal placement and selection of air temperature sensors.
Provides technical specifications for V3000 sensors.
Links water temperature parameters P27, P28 to diagnostic functions.
Explains the operation and algorithm of the water changeover sensor.
Details the factory-set Proportional Integral Derivative (PID) control parameters.
Describes the neutral zone ventilation settings and operation.
Explains the stipulated minimum run time for ventilation speed changes.
Details the parameter for controlling comfort mode override duration.
Explains how the standby button activates different operating modes.
Describes how outdoor temperature limits electric heater operation.
Covers the management of hydraulic and electric heat exchanger coils.
Configures inputs D1/D2 for external contacts like frame sensors.
Provides instructions and diagrams for wiring window contacts.
Details the various ways the fresh air function can be utilized.
Describes different methods for master/slave configuration.
Provides important notes regarding master/slave operation.
Step-by-step guide for configuring master/slave units.
Instructions on how to remove or reset master/slave configurations.
Introduction to the radio-frequency remote control and its receiver.
Steps for configuring the remote control with its radio receiver.
Guidance on the normal operation and use of the remote control.
Information regarding the low battery indicator and replacement.
Configuring the remote control for master/slave operation.
Procedure to remove associations between remote controls and receivers.
Technical drawings showing dimensions for the blank terminal.
Technical drawings showing dimensions for the wall-mounted dial terminal.
Technical drawings showing dimensions for the display terminal.
Technical drawings showing dimensions for the radio-frequency receiver.
Illustrates the layout and connections of various terminals.
Shows the wiring for power supply and KNX bus connections.
Important notes regarding the wiring of the user terminal.
To Next Page
