CIRCLE M7 - Page 14

Document: Service Manual
Description: Treadmill
Model: M7 LED
Page: 14 of 60
14
2.22. Incline window show『Err』, incline lose function but other functions normal:
Press and hold『STOP』then press『START』
3 seconds to enter engineer mode.
Reset power
OFF
ON
Press『Enter』till dot-matrix show『IO』.
Press『incline up』to drive incline motor.
Does incline motor move？
Yes
No
Incline motor jammed, have to
eliminate and try again.
Is parameter can be increase up over 700 when
motor move up？(Press incline up again to stop the
incline motor while parameter over 700)
Yes
System operating normal
No
Replace incline
motor
No
Replace
inverter