15
3. ENGINEERING MODE
3.1. Engineering mode 1: Test mode
3.1.1. Press and hold『Stop』key then press『Start』3 seconds to enter the engineering mode
while in idle mode. The display will show software version, press『Enter』to begin the
test mode.
3.1.1.1. All display will flash together, press『Enter』to next test mode.
3.1.1.2. LED scan mode: this is for production test mode, press『Enter』to next test mode.
3.1.1.3. LED pilot lamp scan mode: this is for production test mode, press『Enter』to next
test mode.
3.1.1.4. Keys test mode: dot-matrix show【KEY】, each key has their own code when press a
key, the code show as below, press『Enter』to next test mode.
3.1.1.5. Test mode: Press Start can drive motor, press speed keys to change speed, press
incline keys to drive incline motor, press『Enter』back to 4.1.1.1. retest, press and
hold『RESET/CLEAR』then press『Quick Start』3 seconds to exit.
To Next Page