CIRCLE M7 - Engineering Mode 2: Factory Settings

Document: Service Manual
Description: Treadmill
Model: M7 LED
Page: 16 of 60
16
3.2. Engineering mode 2: Factory settings
3.2.2. Press and hold『Stop』key then press『Fast』3 seconds to enter the engineering mode
while in idle mode.
3.2.2.1. Software version : Dot-matrix show【VER】, time window show software version,
press『Enter』to next setting.
3.2.2.2. SET LANGUAGE : Dot-matrix show【SET LANGUAGE】one time then show
『ENGLISH』, press▲ or ▼ change to『NEDERLANDS』or 『FRANCAIS』or
『DEUTSCH』or 『ITALIANO』or 『ESPANOL』, press『ENTER』to next setting.(This
function only for software version great than 1.09(include))
3.2.2.3. SET UNIT : Dot-matrix show【SET UNIT】one time then show『METRIC』, press▲ or
▼ change to【ENGLISH】, press『ENTER』to next setting.
3.2.2.4. FAN SETTING : Dot-matrix show【FAN SETTING】one time then show『ON』, press▲
or ▼ change to【OFF】, press『ENTER』to next setting.
3.2.2.5. MIN SPEED : Dot-matrix show【SET MIN SPEED THEN PRESS ENTER】, SPEED
window show value, press▲ or ▼ to set value, press『ENTER』to next setting.
3.2.2.6. MAX SPEED : Dot-matrix show【SET MAX SPEED THEN PRESS ENTER】, SPEED
window show value, press▲ or ▼ to set value, press『ENTER』to next setting.
3.2.2.7. MAX ELEVATION : Dot-matrix show【SET MAX ELEVATION THEN PRESS ENTER】,
INCLINE window show value, press▲ or ▼ to set value, press『ENTER』to next
setting.
3.2.2.8. Total used distance : Dot-matrix show【ODO】, DISTANCE ＆ TIME window show
total used distance. Total used distance= TIME window value + (DISTANCE window
value X 10000) , press『Reset/Clear』+『Enter』5 seconds can erase total used
distance value, press『ENTER』to next setting.
3.2.2.9. Total used hours : Dot-matrix show【HRS】, TIME window show total hours value,
press『Reset/Clear』+『Enter』5 seconds can erase total used hours value, press
『Enter』back to idle mode.