CIRCLE M7 - Page 9

Document: Service Manual
Description: Treadmill
Model: M7 LED
Page: 9 of 60
9
2.14. Error message『Err7』:The incline motor position parameter over max or min limit, check
the incline motor connect to inverter certainly show as below. If connection well, replace
inverter and update the console program version to the newest version.(great than V1.06)
2.15. Error message『Err6』:Incline motor cannot reach set position over 42 seconds
Show Err6
Reset power
OFF
ON
Does incline motor moving?
Yes
No
Incline motor jammed, to eliminate jam problem then
check the inverter shall be the new version (refer to 1.3.)
and console firmware version great than V1.05, if not,
replace or update it.
Is it move about 1~2 then stop？
Yes
No
Press Start then set incline
to 15.
System operating normal but please check the inverter
shall be the new version and console firmware version
great than V1.05, if not, replace or update it.
Replace incline motor and check the inverter
shall be the new version (refer to 1.3.) and
console firmware version great than V1.05, if
not, replace or update it.